code e-27 error code

Nissan Sit down Rider LP Gas Forklift questions and answers
Post Reply

code e-27 error code

Post by Henry »

This Nissan lift with the K21 engine is showing code e27 on panel. I replaced the crank sensor but engine is still running rough with a lack of power. No change in how it runs between the old crank sensor and the new one. I have also replaced the cam sensor.
Posts: 64
Joined: Fri Aug 26, 2016 8:38 pm

Re: code e-27 error code

Post by hiandlotech »

Hello!! And welcome to

E-27 is defined as a crank sensor code, Since you have replaced the crank sensor we can rule that out, if you have not already done so make sure all ignition connections are where they are supposed to be.
It is an ignition related code, it is possible that something as simple as the spark plug gap being too worn out or even bad spark plugs, best best is to start with a basic tune up.
See Error Code Chart

Replace spark plugs and make sure the GAP is correct, which is 0.38 (.096mm) if the gap is wider it could trigger that code, the code may still be present so to refresh the dash disconnecting the battery may not always reset it you would have to do the manual pedal reset which goes as follows.

Just remember 3-5-7

Turn the ignition switch on with accel. pedal released,after 3 seconds fully depress the accel pedal 5 times within 5 seconds(end in released position). After 7 seconds(timing is very important...1 mississippi 2 mississippi etc....) press and hold down accel pedal for approximately 10 seconds(again timing) until the hour meter starts blinking, release pedal and push down and hold again for 10 seconds) hour meter should be on with no codes showing,shut key off and test to see if codes cleared.
Caterpillar Certified- Nissan Certified
Clark Technician- Jungheinrich
mexiCAN :mrgreen: :mrgreen:

Re: code e-27 error code

Post by calycat »

buy a cheap code reader, obd11,it clears it , ived done it many times on these engines,,
Post Reply